Modular Synth Panels

The 3-jack will work for one of the PCBs, or both if you stack them, 
using short standoffs and maybe laying the electrolytics on their 
sides. Mind you, I haven't tried that.

The 2-pot should work spacing-wise above, but it will need to be 
clipped a bit for the other side's pot to get in there.

Cheers,
Scott Deyo
The Bridechamber
contact@...
http://www.bridechamber.com
Jealous Edison Record Kompany
http://www.jealousedison.com


On Jun 15, 2008, at 7:56 AM, Richard Brewster wrote:

> I was wondering what brackets to use for the Tellun Lag Processor. The
>  prototype used the old Stooge bracket approach and I don't believe 
> these
>  brackets are available any more.
>
> http://www.tellun.com/motm/diy/tln862/TLN-862p.html
>
>  I'm getting the panel from Bridechamber.
>
> http://www.bridechamber.com/bridechamber.com/T%20Lag.html
>
>  If anyone has built this project, I'd like to hear how it was done.
>  Would some of the Bridechamber brackets work? I was thinking that
>  perhaps two 2-pot brackets or a 2-pot plus the 3-jack bracket might 
> work.
>
> http://www.bridechamber.com/bridechamber.com/Brackets.html
>
>  Thanks,
>
>  Richard Brewster
> http://www.pugix.com
>
>  
>