The Kawai & Teisco Analog Synths Group

Not at all !

It is a very simple operation and I guess that it should be done the 
same way the mod fpr Polysix goes... But you'll have to consult an 
electronician. If I remember correctly all needed to be done is to 
remove a resistor and put a diode instead of it.

I personally didn't do that and placed a new NiCAD battery, far away 
from the PCBs. I intend to replace it every few years. I guess this 
particular machine is going to be needed to be serviced quite a lot 
at the near future. I already had to recover the computer board after 
memory leak and replace two filer chips.




--- In kawai_sx210@yahoogroups.com, "Emile Gauthier" 
<emilegauthier@o...> wrote:
> 
>   It's very hard to change the board to put a lithium battery, you 
must be a very good electronician.
>   I dont own a user manual unfortunatly, it would be very 
helpfull...