Homebrew PCBs

On Fri, 14 Jul 2006 19:40:57 +0200, derekhawkins <eldata@...> wrote:

>
> The transparencies/fine (paper/quality) setting should use the least
> amount of ink. Don't use any of the Photo media settings. Epson's
> inkjet transparencies are just standard film with a very thin absorbent
> layer on one side that scrubs off quite easily with water. However,
> it's the consistency and absorbency of this layer that makes them so
> good compared to others.


The transparency setting does not use any black ink.

I was surprised by that as well, but i tried all settings and transparency  
mixes black from the colors instead. This is the only setting that does  
this.

ST