>All you Blacet afficianados take note:
>
>John let me know today that all his new design pcbs (and hopefully old ones
>as he revs them) will have corner mounting holes even though he doesn't use
>them himself. YIPPEEE! And I didn't even have to nag him about it<g>...
>
>This removes the single trickiest obstacle to mounting Blacet modules on our
>custom panels.
>
>John has gone the extra mile to cater to us several times, so I'd just like
>to say THANKS JOHN!
>
Very cool! I'll add my voice to the chorus of thanks!
However, it's too late for me and my Time Machine. So, I'm looking for
suggestions about where to dril the holes to mount it to my brackets.
Looking for spots with no components or traces, I've found the following
locations:
Between R1 and R2, in the upper left corner of the board
Between R3 and R4, in about the middle of the left edge of the board
Between D3 ands RN8, about the middle of the bottom edge
To the right of U15, about 1/3 of the way down the right edge
My question, to John or anyone else building the Time Machine in a MOTM
package, is, will I seriously screw up anything if I drill in these
locations? Any better suggestions?
____________________________________________
Dave Trenkel :
improv@...New & Improv Media
http://www.newandimprov.comNow available: Admiral Twinkle Devil: Wabi Dub
____________________________________________