Well, it is exciting to me.
My web site is now accessible again and improved while it was gone.
Access it at
http://24.12.85.234/larryHere is what is new:
- VISIO templates for MOTM modules from Fred Beecher
- New faster loading GIF format schematics
- 822 and 831 builders FAQ. All e-mailed questions will get added to this.
- Users forum - this is a place I am making available for users who
want to share those great photos or MP3s or whatever and need
a nice place to have them available to the group. No stinkin' Yahoo
password required. If you want to have your stuff here, just e-mail me.
Update on 822 and 831 instructions -
- Calibration instructions are finished and the beta tester says GO.
So, I will be giving them one additional proof reading and will
post them.
- 822 assembly instructions are finished and proof read by me. They go
out for a second opinion this weekend and will be used to actually
construct one 822 to check them for usability.
- 831 instructions are almost finished - I need a volunteer to look
these over. My 822 tester does not have an 831
All of these instructions shoud be ready for down load early next week.
More good news. I have several people interested in 822 PCBs. If I get
just a few more, we have a second run. Price will be the same. They will
have solder-mask this time.
Some bad news - the brackets are GONE. Unless you have been one
of the 3 or so people who ordered in the last couple of days, it is now
too late. However, I think everyone who wanted them and needed
them did get them. I will consider another run if there is enough demand.
However, I cannot buy less than 200 at a time.
Larry Hendry