mate_stubb@... writes:
>>Did you forget the little jumpers on the cv input jacks from ground lug to
normalling lug?<<
That was a good suggestion. It sounded like that might have been it, but I
checked and they are there. In fact if I just insert an unconnected plug
into a CV jack, the LED turns green. There is some info in the manual about
what voltages I should be seeing on certain pins on the chips. I'll have to
check that out. The module basically works, it's just that the knobs seem
way off and don't behave like the "Preliminary Check-Out" in the manual.
-Elhardt