Did you forget the little jumpers on the cv input jacks from ground
lug to normalling lug?
Moe
--- In motm@y..., elhardt@a... wrote:
> Today I'm hearing my MOTM for the first time. The only mistake I
made was
> swapping the FM1 and FM2 pots on one of my 420 filters (easy to
correct).
> Everything else in my blue case seems to work fine, except the
behavior of
> probably the simplest module (MOTM-700) is strange. I can plug in
an LFO,
> VCO or EG and watch the LED go from red to green based on the CV
input. But
> I have to set the knob/switches down to between -4 and -5 to see
that happen.
> With no cable in the CV input, I can't turn the switch and see the
LEDs flip
> as the manual indicates. There are no adjustments on the board.
Both
> channels behave exactly the same. It does switch between two
different audio
> inputs and therefore seems to function. It almost seems like the
values of
> the pots are wrong yet they match the manual. Has anybody seen
this problem?
> If not, I'll have to troubleshoot it. Thanks.
>
> -Elhardt