In a message dated 7/10/99 10:14:49 AM,
jlarryh@... writes:
My fault Larry, I'm confusing my variables again -- if you're going to mix
some metaphors, you've gotta break a few legs. I'd been calling the mythical
module a 900-X, but today I referred to it as a 9X0 (like MOTM-940 or
MOTM-900). Sorry, it's still a bit early for me. But in the interest of
completeness, it would have the same hole pattern as the MOTM-940 Patch Panel
but half as wide -- so 16 holes total.
John "chip off the cold shoulder" Barlow
>> What I've been thinking is having a 1U 9X0 patching module at the extreme
>Ok, I am getting your drift. However, I am missing something. If you
>have
>9X0 on a 16 IU, you can only have one (9X2=18). Does each 9 on this panel
>connect to the 9 on the other panels or what? "Splain it to be a little
>better please Lucy"