I picked them up today and they are VERY nice. I shot just a quick photo
showing the two sizes with 831 (the bracket does not yet have the 831 trim
applied) and time machine PCBs laying on them so you can see the fit. You
can trim the time machine panel down to PCB width if you choose, but it is
not necessary as the extra does not interfere with anything else on the
panel. Of course, the standard MOTM size PCB and protoboard fits and holes
are provided. Notice the holes are slotted. That makes fitting easier.
And, notice the holes on the front. They are slotted out 1/4 of an inch
giving you maximum flexibility for the location of the PCB side to side
behind the panel. If you are using rotary switches on your project instead
of pots, small "lock" holes are provided for the rotary switch stop so it
will not turn.
Shipping starts tomorrow. Thanks to everyone that ordered. Packages will
ship immediately on receipt of payment.
I ordered some extra, so if you have a need for one later, there is a good
possibility I might have one.
Link to photo:
http://www.modglin.com/larry/long-short.jpgLater,
Larry