Lots of Switchcraft jacks!!! Aluminum!!! 1U only!!! No bends!!! No
additional screws visible on front panel. Have the shop work up a 19" 1U
panel and see how it acts. The lots of jacks should stiffen it a little. A
welded crossmember is the best solution for me for support.
What will the DC source do for me?
CV control knobs? X-Y Joysticks? Trigger buttons? Two different types of
panels, but fabricated the same way to get cost down and have people buy
more?
--Todd
> -----Original Message-----
> From: Paul Schreiber [mailto:synth1@...]
> Sent: Thursday, July 08, 1999 9:36 AM
> To: MOTM listserv
> Subject: [motm] MOTM 19" wide, Part 2
>
> From: "Paul Schreiber" <synth1@...>
>
> 1 more thing....
>
> A 1U tall, 19" wide panel ∗may∗ no be stiff enough in the middle
> not to flex a bit when inserting jacks.
>
> a 2U tall most definitely will NOT budge.
>
> I will see if the metal shop will fab a dummy panel. Else, I may
> use steel (boy THAT would weigh alot! But since it would look like
> Swiss cheese, maybe not that bad)
>
> OR...I could have the part L-shaped form 0.090 material....I'll keep
> pondering.
>
> Maybe use 0.125 Al but have support steel frame screwed in behind it......
>
> Paul S.
>
>
>
> --------------------------- ONElist Sponsor ----------------------------
>
> How has ONElist changed your life?
> Share your story with us at http://www.onelist.com
>
> ------------------------------------------------------------------------
>