That's it Larry! Thanks! I probably do have an updated instruction manual
since I didn't buy my VCOs at the same time. The manual that I looked at
didn't have any mention of it.
JB
In a message dated 12/26/2000 7:18:31 PM,
jlarryh@... writes:
>The "official" MOTM soft sync mod is to put a 4K7 resistor in series with
>the sync jack connection. This shows up in the latest revision to the
>300
>documentation (published on 7/25/99 after many of us built our first round
>of VCOs) on page 17. The unused top lug on the jack is used for the
>connection point so the resistor does not need to dangle like it does on
>those crummy jacks (bananas weren't they) you were using. :) The wire
>to
>the PCB connects to the top lug and the resistor goes from top to left.
>