The "official" MOTM soft sync mod is to put a 4K7 resistor in series with
the sync jack connection. This shows up in the latest revision to the 300
documentation (published on 7/25/99 after many of us built our first round
of VCOs) on page 17. The unused top lug on the jack is used for the
connection point so the resistor does not need to dangle like it does on
those crummy jacks (bananas weren't they) you were using. :) The wire to
the PCB connects to the top lug and the resistor goes from top to left.
Stooge Larry
----- Original Message -----
From: <jwbarlow@...>
To: <motm@egroups.com>
Sent: Tuesday, December 26, 2000 8:48 PM
Subject: [motm] 300 VCO soft sync mod?
Does anyone have the latest (best?) soft sync mod for the 300 handy? I'm
finishing changing out my jacks (and replacing my substandard switches -- I
broke em while trying to compete with Larry for the Mr. MOTM Universe
competition) in the rest of my MOTM, and I have these resistors dangling off
the sync inputs for reasons which I can't remember.
JB