Hmmm......I suppose you can raise it off the pcb some to contact the 2
transistors. But it doesn't
matter ∗that∗ much, since it runs at such a low frequency.
Paul S.
----- Original Message -----
From: <elhardt@...>
To: <motm@egroups.com>
Sent: Monday, December 25, 2000 12:42 AM
Subject: [motm] MOTM-320 Tempco Placement?
> Question:
> On the 320 LFO, the tempco resistor is supposed to touch Q1 and Q2, yet
the
> instructions say in bold face to be sure that the tempco resistor is "all
the
> way flat on the pc board surface". It would make far better contact with
Q1
> and Q2 if left about 1/10 of an inch above the pc board. Is it more
> important that it sits flat on the pc board then make good contact with Q1
> and Q2?
>
> Thanks
> -Elhardt
>
>
>
>