I have had great success tapping the vast experience of the guys on
synth-diy on topics outside my simple reach. The best list going on the net
IMHO (even if I cannot understand much of it). :)
Larry H
----- Original Message -----
From: <ixqy@...>
To: <motm@egroups.com>
Sent: Sunday, December 03, 2000 3:58 PM
Subject: Re: [motm] STC rant ...LONG and OT
I just got through last week ordering new pots for my Craig Anderton ring
mod. Now I'm thinking, how do I change this to work with the MOTM audio
in/out levels?
I'd also like to do another mod... This ring mod only has one audio input.
The other signal that modulates the input is the onboard carrier osc. which
is set by a pot. This means that it's usually a static setting unless you
tweak the pot as you play.
I'd like to mod it to have CV control over the carrier freq. but have no
idea how to go about it. Would I have to use a OTA for this or just patch in
a CV through a resistor directly to where the pot is connected? This IC used
is a 565 pll.
Thanks,
Andrew Sanchez