--
James Holloway
jimh54@... - email
(972) 993-2023 x1188 - voicemail/fax
----
improv@... wrote:
> >I bought a used Doepler MAQ 16/3 yesterday (only until the MOTM is
> done, Paul
> >I swear : )
> Hey, I love my MAQ, and when the MOTM comes out, I'll use it right
> next to
> the MAQ. You can never ever have enough analog sequencers. That Future
> Retro box is lookin mighty purty too...
>
> >Is the a way i can have the MAQ drive both of my 320 vco's ? I dont
> have any
> >mults yet, but may attempt to build something today if this is pretty
> easy.
> >Any suggestions?
> >Jim
>
> I built a simple breakout panel that brings the CV outs of the MAQ
> to the
> front, with 2 jacks for each of the CV and gates. Whoever decided to
> put
> the CV jacks on the lower rear corner of the MAQ had to be stoned,
> it's the
> most inconvenient spot possible, makes it impossible to use the box
> on a
> tabletop. I wired each set of 2 jacks tip-to-tip and ring-to-ring,
> and then
> attached a shielded cable to one of the jacks, with an 1/8" plug on
> the
> end.
>
> ____________________________________________
> Dave Trenkel : improv@...
> Minus Web Site: http://listen.to/minusmusic
> Minus MP3's: http://www.mp3.com/-minus-
> ____________________________________________
>
>
>
>
>
>
> If you bring out the gates and want a combined gate output so you can
have a 48 step sequence you should use diodes to keep them from loading
each other.
__________________________________________________
FREE voicemail, email, and fax...all in one place.
Sign Up Now!
http://www.onebox.com