Hello Gang,
I have a 12 space SKB with one 900 PCB full of modules inside of it. I am
ready to start my second SKB case and plan to run the power lines split
directly off of the power-one supply. Where is the best point to do this or
the best method used in your opinion?
I hope to run the three wires to a one space (MOTM) panel mounted on the
rear of my SKB next to my 900 Power Supply. On this panel I want to have the
MIDI ins/outs from my Kenton and the Power Out Jack to the second SKB. What
type of cable would you recommend to run the three wire power from one
cabinet to the other? XLR? MIDI? What type of cable would be a good one for
this task of power transfer?
On the second SKB I will of course have the receptacle jack for the power
cord run to a 900 PCB mounted on a two space (19" wide) panel. This should
power the whole new 12 space of modules along with the original. Thanks for
your opinions and help.
Thomas White
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at
http://www.hotmail.com