Yes, it's getting the MOTM connectors for good reasons. :)
(And yes, I'm still working on the code for the Expressionist.)
Tony
> -----Original Message-----
> From: Dave Bradley [mailto:daveb@...]
> Sent: Monday, August 21, 2000 8:31 AM
> To: motm@egroups.com
> Subject: [motm] Re: MOTM compatible module
>
>
> --- In motm@egroups.com, "Tony Karavidas" <tony@e...> wrote:
>
> > Paul and I use different graphics tools and I know the font he
> uses, but I
> > don't have the exact one. I'm trying to make it look very close so
> when it's
> > in a system, it's a natural addition. The knobs are smaller
> versions of the
> > ones he uses, but the mounting of the board is completely
> different. There
> > is no information on cost or kit availability yet.
> >
>
> Tony, the module looks awesome. I'm not sure yet which camp I fall
> into - the "less crowded" or the "gimme all the functionality" camp.
> I am planning to use slightly more crowded spacing for my DIY
> sequencers, however. I'd probably have to lay some knobs out on a
> paper panel mockup and see if I could comfortably reach everything.
>
> Are you planning to use the MOTM power connectors?
>
> Dave
>
>
>
>
>
>
>
>