What are some of the patching examples you would use this module on???
Thanks
Jim
sikorsky wrote:
> From: Paul Schreiber <synth1@...>
> Subject: [motm] Food for thought
>
> > Just a sneak peek at PIC modules in development.
>
> hello all,
> love the new modules,
>
> the clock divider - maybe that could stretch to a 3u panel..? that way there
> could also be room for that bank of LEDs that everyone wants ;-). what does
> "ramp ampl." do, something to do with trigger threshold on /N..? or am i
> wildly off the mark here -
>
> ratio divider - i'm assuming this is more VCO based, so if i set it to 2:1
> and chucked 440Hz into it, i'd get 220Hz out of it, what's available ratio
> wise - integers between 1-32 again..?
>
> dual delay - could the buttons be replaced by some kind of rotary
> encoders..?
>
> size, permitting, maybe the display could be put in the top left hand pot
> position, allowing the pots & jacks (especially on the ratio divider) to
> take up a more natural MOTM layout. also if you only need to cycle from 1-32
> on the dividers, is there a need to include a fine / course control - or was
> this added as a performance control..?
>
> anyway, as always, i can't wait for these new modules and look forward to
> spending those dark winter evenings happily dividing by N
> oh yes - i've one more thing to add to the debate - NIXIE TUBES !!!
>
> cheers paul b (ducking)
>
>