See attached image which was generated for a drilling template. Left half
represents all jacks, ala MOTM-940. Right half represents 2 rows of jacks, 4
pots, and up to 8 switches. All dimensions measured with micrometer at a
machine shop from a MOTM-300 panel (except for the left half pattern for
mults). Notice the switch locations are closer together than the jacks.
Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@... > -----Original Message-----
> From: sikorsky [mailto:vulture.squadron@...]
> Sent: Monday, July 10, 2000 3:37 PM
> To: motm@egroups.com
> Subject: [motm] panels specs
>
>
> hello all,
>
> it's diy panel time again for me, and as i couldn't find anything in the
> archive, for the diy-ers amongst us (especially those who work in metric)
> i'd like to clarify a few panel measurements
> anyone care to comment..?
>
> mounting holes
> 3/16" diameter, centre is 1/4" from each edge
>
> pots
> first pot is 15/16" from upper edge, second pot is 1 5/8" from
> first pot etc
> bottom (fourth) pot is 2 15/16" from lower edge
>
> jacks
> bottom row is 7/8" from lower edge
> top row is eactly 1" above bottom row
> on a 1U panel jacks are 7/16" from left / right edge
>
> panel is 8 3/4" by 1 3/4" (easy bit)
>
> cheers
> paul b
>
>
>
> ------------------------------------------------------------------------
> Need a credit card?
> Instant Approval and 0% intro APR with Aria!
> http://click.egroups.com/1/6034/6/_/529958/_/963261623/
> ------------------------------------------------------------------------
>
>