Shemp,
See responses inserted below:
> From: Tentochi <tentochi@...>
> Well, since there has been a lull in new modules,
> I thought I would work on some "compatible" modules
> and convert them over as much as possible to the
> MOTM format. Obvious things are:
>
> Front Panel
> Pots/Knobs
> Jacks
I found the Bourns 50K pots to be a good reasonable solution for the 50K
pots in other Blacet kits I converted. These are like the one's Paul used
in the EG - blue with plastic shaft. I could not find the 50K Spectrols
with 1/4 inch shafts anywhere anymore. Here is a source for some of the
MOTM same parts you may want to use:
Bourns part # 91A1A-B24-B18 50K linear pots
Allied part # 754-9418, page 717
Switches can be found at:
NKK switch # M2102ES1W01 - SPST on/on toggle switch
Allied part # 870-8646 - page 274
NKK switch # M2103ES1W01 - SPST on/off/on toggle switch
Allied part # 870-8647 - page 274
Knobs
Newark Part number 57F2348 Alco part number PKES-90B-1/4
LEDs:
RED: Digikey # = 67-1155-ND Lumex number = SSI-LXH387ID
GREEN: Digikey # = 67-1156-ND Lumex number = SSI-LXH387GD
YELLOW: Digikey # = 67-1157-ND Lumex number = SSI-LXH387YD
Everyone has the 112A jacks.
> Difficult things (for me) are:
>
> Converting a 12v module to use the 15v MOTM PSU
Oh, John ought to speak to that. The modules I got from him were 15 volt
compatible.
> Hooking up power supply connector
The Blacet connectors will work. However, they do not lock the same. You
can change and use the exact one used by Paul. They fit the Blacet boards
I made. They are about 11 cents.
AMP part # 640445-4 MTA-156 post headers for circuit board mounting
Allied part # 512-3452, page 476
> Opamps to replace with higher quality opamps
Hmmm... Why? Isn't a Dark star about Chaos?
> Other parts which should be upgraded
Can't think of any.
> Connecting the PCB to the MOTM front panel
I used a MOTM bracket (purchased from Paul). I drilled holes in my Blacet
PCBs in locations not offensive to the circuitry and the drilled holes in
the bracket to match. I used very nice looking black hex head bolts to
connect the bracket to holes through the front panel.
> I am currently working on 2 Blacet Dark Star Chaos units. Actually these
> boards are easier to stuff--the part numbers are sequential and easier to
> read on the PCB. But the instructions aren't nearly as detailed and
> organized. Thanks Paul!
With no offense intended to ANYone. NOBODY writes instructions as detailed
and easy to follow as Paul. I have built kits from PAiA, Blacet, and Big
Briar. While all instructions were at least adequate (and some better than
others), Paul's were clearly the best.
Stooge (these opinions belong only to the stooge that lives inside of me
and do not always reflect the views and ideas of the host body, and no I
don't have a personality problem) Larry