Larry and Ken have done great work on their FPs, and Ken's "how to make a
custom MOTM FP" page is very thorough -- I haven't done any MOTM diy stuff
yet (since I have too much MOTM for my already full rack and I want to build
a REAL cabinet when those flat rack rails are ready -- hint). When I do some
diy MOTM stuff, I'm going to follow Ken's directions, though I am interested
in what Moe's got going.
In a message dated 5/10/2000 8:05:05 AM,
blacet@... writes:
>Excellent lettering job on the MOTM/Blacet Mixer. It even says "Blacet
>Research..." on the bottom. Now I'm scared because people will think
>this is a standard product!
There was recently an offlist discussion about how we might label our
(non)MOTM panels -- how about adding one word: "CUSTOM" in front of Blacet
Research?
In a message dated 5/9/2000 6:40:27 PM, shemp (who takes his horticultural
taxonomies seriously) writes:
>Alright Paul. Here it is again! And Blacet is in on it this time doing
>everything he can. The first colaboration module!!! Make up a front panel
>and supply the extra MOTM-certified parts to complete the set-up. I'll
>take
>2 of these special kits just to get the ball rolling! $40 each?
In a message dated 5/9/2000 7:05:53 PM,
tentochi@... writes:
>I meant a Synthesis Technology manufactured front panel and appropriate
>jacks, pots, etc. All the way up to full MOTM spec on the extra parts.
Unfortunately I think that Larry and Ken paid a lot more than $40 each to get
their Blacet modules to look MOTM. I'd bet it was closer to $70 (6 pots/knobs
X $7.50 + 6 1/4" jacks X $1.50 + FP + graphics + brackets).
But someone should think about this!
JB