Aftrer some "tweaking" I did get the cable to work, it must have just been
a loose connection, I think the grounds weren't making contact. -Nate
>
>
>
>In a message dated 5/8/2000 5:43:52 PM, synth1@... writes:
>
>
>
>>Sure it wasn't a bad '800?
>
>
>
>Send it to Barlow as scrap!
>
>
>
>>Check the wiring on the cable. I have seen 1 (out of ~1000) cables that
>
>>had
>
>>the 2 outside wires 'crossed'. I now try to check for this as I pack them
>
>>up.
>
>
>
>About 6 months ago(?) there were some power cables that needed a bit of
>
>tweaking upon receipt due to some less-than-MOTM-like assembly. Paul gave us
>
>a quick fix to make them up to spec (and offered to replace them if one
>
>wished), maybe you have one of those cables, eh?
>
>
>
>Last I heard, that poor MOTM cable assembler was still eating thorough a
>
>straw.
>
>JB
>
>
>
>