ALWAYS compare the orientation of the writing on the top with the other ICs
if there is any question.
Paul S.
----- Original Message -----
From: Nathan Hunsicker <nate@...>
To: <motm@egroups.com>
Sent: Friday, April 28, 2000 7:41 AM
Subject: Re: [motm] 410 HELP!!!
You're absolutely right!!! Why do they have to confuse me by putting a dot
and a notch on the case? I must have checked it 10 times before noticing.
-Nate
>
>IT'S IN BACKWARDS!!!!
>
>
>
>Paul S.
>
>
>
>----- Original Message -----
>
>From: Nathan Alan Hunsicker <nate@...>
>
>To: MOTM Newsgroup <motm@egroups.com>
>
>Sent: Thursday, April 27, 2000 10:57 PM
>
>Subject: [motm] 410 HELP!!!
>
>
>
>
>
>> I just finished the 410 tonight, the filters work fine as do the depth &
>
>> sweep controls however, I cannot get the internal LFOs to work. My rate
>
>> knob does nothing and upon further investigation I found that the TL074
>
>> op amp is getting VERY hot. Any ideas? I double checked all my
>
>> connections and solder joints, everything is in the right place and
>
>> facing the right way. I cannot figure it out, any help would be
>
>> appreciated. Thanks -Nate
>
>>
>
>> ------------------------------------------------------------------------
>
>> Was the salesman clueless? Productopia has the answers.
>
>>
>><http://click.egroups.com/1/3019/3/_/529958/_/956894148/>http://click.egro
ups.co
>>m/1/3019/3/_/529958/_/956894148/
>
>> ------------------------------------------------------------------------
>
>>
>
>>
>
>
>
>
>
>
------------------------------------------------------------------------
Get paid for the stuff you know!
Get answers for the stuff you don't. And get $10 to spend on the site!
http://click.egroups.com/1/2200/3/_/529958/_/956925768/
------------------------------------------------------------------------