Did the original message from below go out to the list?
--PBr
> -----Original Message-----
> From:Dave Bradley [SMTP:daveb@...]
> Sent:Thursday, April 27, 2000 10:44 AM
> To:MOTM List
> Subject:[motm] FW: ∗∗MOTM-820 VC Lag PCB ISSUE∗∗
>
>
> > This is easily accomplished by "blobbing" solder (the no-clean
> > type) on the
> > 2 pins of the IC.
> > [For some of you, this will come naturally].
> >
>
> Another way is to cut a very short length of scrap resistor lead, just
> long
> enough to bridge the two pins - mechanically, it's sounder.
>
> If you're taking orders already, I'll take one (kit)! When is the
> projected
> shipping date?
>