Ken,
See the attached jpeg. It appears that the brace is glued into a routed slot that is
set back from the front of the cabinet. I presume that the brace is assembled with
the top and bottom.
Eric
--- "Tkacs, Ken" <
ken.tkacs@...> wrote:
>
> Thanks!
>
> When you say 'glued into slots,' are these slots that are built up from wood
> shims, or are they chiseled into the side panels...? Maybe they are cut into
> the side panel with a router, and then the beams are glued and hammered
> until they 'pop' into place...? Am I over-thinking this?
>
> If you could take a close look tonight, I'd appreciate it. I was looking on
> the web for photos, but the photos people take show more of wiring
> harnesses, modules, etc. and not so much the wood cabinet joinery and the
> wooden exteriors.
>
>
> -----Original Message-----
> From: alt-mode [mailto:alt_mode@...]
> Sent:Monday, 17 April, 2000 4:43 PM
> To:motm@egroups.com
> Subject:Re: [motm] Cabinet Question -- Assembly
>
>
>
> The main horizontal beam on a Moog lower cabinet is glued into slots on each
> side.
> I'll have to check if it is visible. There is one brace in the middle of
> the beam
> connecting to the bottom of the cabinet. This evening I can send out one of
> the
> pics I took showing the flat rails that also shows the joint at the side of
> the
> cabinet.
>
>
>
>
__________________________________________________
Do You Yahoo!?
Send online invitations with Yahoo! Invites.
http://invites.yahoo.com