> Is there a way to have my MTOM-900 rebuilt this way? If not, I'll keep it
> and plan to use it in the rear of my future cabinet for powering more
modules.
Not easily.
>
> Also, are there longer power bundles for when we have modules pretty far
> from the power supply?
30 inch ones are in the PDF catalog.
>
> More thoughts:
>
> 1. Can the power supply be made 2 units wide instead of 3? The PS could
> be rotated 90 degrees to have a smaller footprint on the panel, then the
> connector board could be put on a plate mounted to the PS or to the new
> enclosure so that the connector board would not occupy any panel footprint
> area. Yes rotating the PS will make it a deeper unit, but I see no reason
> to limit MOTM module depth to what we have so far. None of our cabinets
> will be smaller than a foot in depth I would imagine.
No, because the MOTM form factor was designed ∗specifically∗ to go into a
SKB pop-up mixer case.
Why? Because the Fenix did NOT fit in one, caused ∗many∗ lost sales.
> 2. Can we have a cool red indicator light (or LED) added by the power
switch?
Knock yourself out.
drill a hole, buy a Lumex LED from Digikey and a 2.2K resistor.
> 4. There could be an outlet on both the front and back of the module, and
> a rubber or plastic cover could be placed over the unused outlet.
Complicates the wiring. This is supposed to be the easy kit :)
> 5. Can we have a little voice chip activated at power-on say something
> cool or funny through a little internal speaker? Example: "Paul
> Schreiber Rocks!" "MOTHER!" "MAMA" "Kewl" or maybe just a cool sound
> effect. Just brainstorming as usual.
Mine does this all by itself.
Paul S.
>