Hi Friends,
The 900 power supply will power around 22 modules so you should be right
around capacity with 20. Add up your milli-amps and see what your total will
be. 800 is the max if I remember correctly. I plan to power 4 rows from one
supply in my set-up and I don't anticipate any problems.
I mounted my power supply on the rear rails of my SKB case and I will mount
the distribution board for my 2nd SKB on the rear as well, mounted to a
blank MOTM panel with one cord connecting the 2 cabinets for power. Should
be a tight transportable system when I'm finished. Your module plan is very
similar to mine, but I now think I am going to go towrads a polyphonic
modular in the long run. Wish me luck and patience. Thanks for listening
Thomas White (8 modules with 2 on the way!) MOTMMOOGERBLACET spaceship
leaving in fifteen minutes for deep space launch...
>So here's what I finally end up with:
>
>Qty SpcsDescription
>--- ---------------
>36300 Ultra VCO
>24320 VC LFO
>12410 Triple resonate filter
>24420 VCF
>12700 VC Router
>33800 ADSR
>24940 Patch Panel
>12440 SSM VCF
>12110 RM/VCA
>
>I already have:
>13900 Pwr
>12100 Noise/SH
>12110 RM/VCA
>12120 Sub-Octave Mux
>
>I will also need:
>3Rack rails
>1Extra power distribution pcb
>
>I'll only have two VCAs and know I will need more, but I'll
>wait for the new one. That's 38 spaces, four rows, with a
>2U open. I guess I'll either save that for the next goody,
>or use it for a breakout of an expressionist. That also
>brings me up to 20 modules, so I guess I can use my motm
>points to get two free modules. Brings me close to 2k,
>which is what I planned to spend anyway.
>
>Good grief, I'm drooling...
>
>Thomas
______________________________________________________
Get Your Private, Free Email at
http://www.hotmail.com