Well folks,
I've sent my sequencer designs to Paul. Where's yours? I cheated, however.
There's no way to get a bunch of knobs on a 3U panel and all the jacks
needed to do anything really interesting. I submitted 3 modules, based on
ideas stolen from the Emu modular sequencer, but in a MOTM format:
1. A 2U 4 stage address generator, with chaining capability, set inputs and
pushbuttons for each position, hold, rnd, and down. Don't need a reset
because of the set inputs.
2. A 4U 4x4 matrix voltage source.
3. A 2U gated 4 input mixer, that can be used with the address generator for
a simple 4x1 sequence, or to control the matrix voltage source output to get
8x2 or 16x1 configurations.
Later!
Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@... > -----Original Message-----
> From: Paul Schreiber [mailto:synth1@...]
> Sent: Saturday, February 06, 1999 5:21 PM
> To: motm@onelist.com
> Subject: [motm] Re: Why not breadboard a small MOTM sequencer?
>
>
> From: "Paul Schreiber" <synth1@...>
>
> How about a small sequencer design contest? On paper, a 2U or 3U
> wide panel.