Archive of the former Yahoo!Groups mailing list: MOTM

Hi Paul n All !

I'd go for the 2u design, more functionality that way .

Can't see what the "wave" knob does on your last proposal .

On the trimmer : with one extra hole in the pcb, many multiturns
could be accomodated, a single turn in the kit would do . This way
the builder has a choice .

I'd like to see two sync modes : one a hard reset, another one a
reversal, like on the cem3340 . Might open the door to lots of weird
control waveforms . (Only do-able if the osc is based on a triangle i
guess)

One more useful extra could be a gate input to start and stop the lfo
(full cycles), same could be used for a one shot, maybe even giving
counted bursts, with an external counter .

I'm not too crazy about "zero on top" controls . Unless a generous
zero deadband is included, one cannot be sure no voltage seeps
through . The alternative would be a separate input, switch or a
pull-to-invert knob ...

Later .


Keep 'em oscillating :)


Hugo
=