Yes, I know this and I've tried this and still can't get it going. By the
way I read the manual ;)
fRED
>From: "Paul Schreiber" <synth1@...>
>
>Err...read the manual :)
>
>Cross mode requires TWO inputs, IN A and IN B.
>
>Paul S.
>
>----- Original Message -----
>From: <telepath@...>
>To: <motm@onelist.com>
>Sent: Wednesday, March 01, 2000 8:47 AM
>Subject: [motm] MOTM-120 Troubleshooting
>
>
>> From: telepath@...
>>
>> Finished putting together my first MOTM module, the 120 Sub-Octave
>> Multiplexer and power supply.
>>
>> Input A works fine, no problems.
>>
>> Input B doesn't seem to work in Cross Mode. I've checked the wires to the
>> jack and there is continuity to the board.
>>
>> Since Input B doesn't work when in Cross Mode I'm wondering if anyone has
>> any advice on further troubleshooting this problem.
>>
>> Telepathic regards,
>> fRED
>>
>>
>>
>> ------------------------------------------------------------------------
>> GET A NEXTCARD VISA, in 30 seconds! Get rates as low as 2.9%
>> Intro or 9.9% Fixed APR and no hidden fees. Apply NOW!
>> http://click.egroups.com/1/915/2/_/529958/_/951921972/
>> ------------------------------------------------------------------------
>>
>>
>
>
>------------------------------------------------------------------------
>GET A NEXTCARD VISA, in 30 seconds! Get rates
>as low as 0.0% Intro APR and no hidden fees.
>Apply NOW!
>http://click.egroups.com/1/975/2/_/529958/_/951970919/
>------------------------------------------------------------------------