In a message dated 02/28/2000 4:53:32 PM,
alt_mode@... writes:
<< However...where are you planning to put your power supply? If you are
planning to put it in the rear of your case, you will need to plan a bit
carefully to have enough clearance for the power supply and the modules
together.... I'm planning on 8.5" and I'll need to mount the PowerOne supply
sideways on the bottom of the case to make sure it clears all the modules. >>
The power supply will bolt inside the 2.5" deep rear lid, so it will only
protrude slightly into the module space. I just don't want rears of modules
poking out the back when I remove the rear lid.
Ivan