Hi again gang.
I am planning to make a joystick controller on my own as a learning
experience. I will be using the CH Mach-2 joystick from CH products as
previous mentioned in a message by Nathan H. Can anybody help me out with a
schematic for the +5/-5v circuit I need to use with the joystick? I have a
block diagram of the circuit, but nothing specific. I want this to be of
good quality to work into my MOTM so anything complicated is not frightening
at this point. :~)
I like how this joystick can release either spring loaded axis at a time or
both for free floating movement. Would I be able to use the two joystick
buttons to generate 5v triggers to fire EG's or re trigger LFO's? I figure
the panel would include the DB-15 connector, 2 pots, X & Y outs, and maybe 2
Trigger outs? Please advise my friends. 1 connector, 2 pots and 4 jacks = 1
space MOTM panel. Or do I even need the CV adjustment pots due to the
trimmers on the joystick?
Thomas White
______________________________________________________
Get Your Private, Free Email at
http://www.hotmail.com