Sounds like a great idea. I'm not sure how you'd actually make it work. You
want to tie V+ to the normalling lugs of the input jacks, but only if you
are in Atten mode. I guess you'd have to run it through an analog gate per
jack or something, switched by the mode switch. It would take a little
clever designinging to allow a common double pole center off switch to
control 3 separate modes. You could always go with triple throw, I guess.
Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@... > From: "Tkacs, Ken" <Ken.Tkacs@...>
>
> How about if, in Attenuators mode, for any one of the four stages that you
> do NOT plug an input jack into, the knob & output jack act as a
> -10~+10 bias
> voltage source?
>
> I think you could squeeze a lot of flexible function out of a module like
> that with minimal electronics.
>
>