Archive of the former Yahoo!Groups mailing list: MOTM

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [motm] Cy Sawtooth animator MOTM format

From: Greg Wuller <ngwese-list@...>
Date: 2009-07-19

Yup - had the same problem (informed Cynthia about it as well right when they came out). I drilled out the holes and swapped out the top pot with a 16mm variant. The info I got from Cynthia is below:
 
=========================================
24mm Aplha Linear 10K from Mouser

31VA401-f

http://www.mouser.com/

that is a 24mm pot which is too big apparently...

a smaller pot that would fit and have the same feel is 
a smaller 16mm Pot instead of 24mm 

The 16mm Alpha pots I use for most everything is 

31JN401-F
=========================================

-greg

On Jul 18, 2009, at 4:11 PM, Miguel Mendoza wrote:



Hello group, any of you are using one of these in a flat rails mounting cabinet? I didn't see this comented before but this module doesn't fit into a typical cabinet. The Alpha pot for the 'FAT' feature is too big, the PCB also seems a little larger than usual but I think that replacing the pot will work. Anyone fixed this? Do you know if this potentiometer is linear or logaritmic?
 
Even the screw holes are so small that I had to drill them again... Really annoying.
 
Thanks!
 
Miguel.