this is from paul and i thought i would pass it on...
"Use a MOTM-20 or -30 jumper cable (just plug them together)."
probably because this involved power i was expecting something a little more complicated. i am always very relieved after i build a module and power it up for the first time there are no sparks or poofs of smoke!
-patch
--- In motm@yahoogroups.com, "John L Rice" <Drummer@...> wrote:
>
> Possibly the easiest way if there is enough slack on the MOTM-900 wires
> would be to cut the 3 wires going from the supply to the distro board in
> half, strip the ends prepare 3 new pieces of wire with stripped ends long
> enough to reach your 960 and then use wire nuts to connect the ends
> together. Not crimping or soldering required. Now, what the 'best' method is
> I can't say! ;-)
>
> Best of luck,
> John L Rice
>
> -----Original Message-----
> From: motm@yahoogroups.com [mailto:motm@yahoogroups.com] On Behalf Of
> patchdub1972
> Sent: Thursday, June 11, 2009 7:38 PM
> To: motm@yahoogroups.com
> Subject: [motm] installing a 960?
>
> hi folks.
>
> whats the best way to go about installing a 960 to the 900?
>
> thanks!!
> -patch
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>