Assuming this was to go to the list, you've got the basics from MOTM mostly, I'd add a hardware assortment. Also check the bracket size - I think the 310 uses the smaller one, but I may be wrong.
I'd also recommend considering doing an easier module for a first effort. This one is fairly expensive, has a bunch of parts that need to be sourced correctly, and has a bunch of really tight solders, and is pretty hard to debug if something goes wrong. 800's are quite different - inexpensive and easy, and good practice. Also perhaps the 380 and 390.
Whatever you build, you might want to ask here if anyone has a BOM for mouser part numbers - that'll help you get going.
On Fri, Feb 6, 2009 at 11:28 AM, jneilnyc
<jneil@...> wrote:
(I assume this was meant to go to the list...)
From: Argitoth <argitoth@...>
To: jneilnyc <jneil@...>
Thanks for the help!
So, I want to DIY my first module, 310 uVCO to be specific. Besides
solder and tools, what do I buy from MOTM to make it possible to
complete a module?
-PCB
-Front Panel
-Extra Parts
-Knobs
-PWR-20 4-conductor power cable?
-BR-1 Large Bracket?
-Wire Assortment???
-etc.????
--
------------------------------------------------------------------
Stephen Drake
sduck409@...
makeme1witheverything@...