> I'm trying to confirm which fuse to get for a 900 upgraded with a
> HBB15-1.5A power supply.
>
> The unit itself seems to suggest a 1 amp verion of the 239 would work
> for 110VAC. The printed instructions, however, seem to say to use a
> .5 (assuming I'm reading it right). Both of these seem low to this
> admittedly non-electronics-geek, so I thought I'd ask here, since I
> know some of you have done this upgrade.
>
a) you need to use the value printed on the supply, for the proper ∗input
voltage∗. The 110 & 220V fuses will differ by 1/2.
b) you need to use Slo-Blo types if possible. Fuses are 5mm X 20mm (standard
size).
c) since you are fusing the AC input side, that current will be lower than
the output side (which is a lower ∗voltage∗).
Paul S.