I'm building the Jurgen Haible chorus and interpolating scanner into
a 2U module. The panel is very dense and I was trying to figure out
the best way to mount the PCB. I needed the PCB as far to the side
as possible so came up with a bracket arrangement that clamps to the
row of jacks. It's basically a main bracket which screws to a short
strip that sandwiches the jacks. It's quite sturdy. I thought I'd
pass the tip along. It will only work with a row of jacks but I have
several modules built that way.
There's a photo at the bottom of
http://modularsynthesis.com/jhaible/jhscanner.htmDave