Archive of the former Yahoo!Groups mailing list: MOTM

Or there's always the extreme diy approach -
http://www.musicfromouterspace.com/analogsynth/WALLWARTSUPPLY/WALLWARTSUPPLY.php
This with one of Paul's distribution boards and you'd be in business.
Personally I'd rather be using Paul's 900 hardware than this however.

On Tue, Aug 19, 2008 at 12:19 PM, Matthew Hiscock <audio@...> wrote:

Perhaps this would do the trick?

http://www.mouser.com/Search/ProductDetail.aspx?qs=vF2eI8GWwmUzYwDJYiRG1A%3d%3d

Cheap, 240ma, +/-15v - I'd just have to deal with the 5-pin DIN in some way....

On 19-Aug-08, at 12:59 PM, Jonathan Snipes wrote:

What about the Dotcom QPS2:

http://synthesizers.com/q101.html#qps2

could easily switch out the power connectors with the MTA 156 ...

-j

On Aug 19, 2008, at 9:49 AM, Paul Schreiber wrote:

a) I have never seen a +-15V regulated wall wart. I have seen +-12V (they 
use a 5-pin DIN, a la MIDI). But this will not work with MOTM.

b) your best bet is to get a 5U tall case, put a MOTM-900 in there, and 
leave it. Then, when needed, remove modules from
the studio and place in there.

Paul S. 

__________________________________________________

--
------------------------------------------------------------------
Stephen Drake
sduck409@...
makeme1witheverything@...