> In Sub mode, if I turn any of the suboctave knobs
> beyond 2, I hear a lot of buzzing. I think this is expected, and it just
> sounds like buzzing because the original signal is getting
> drowned out. Is
> this correct?
Er, no. You shouldn't hear buzzing unless that's what your input signal
sounded like. Send it a clean single pitch waveform, as hot as you can. In
sub mode, you should hear square waves 1, 2, 3, & 4 octaves lower as you
turn up the outputs. Make sure your input waveform is high enough in
frequency, or the lower octaves output by the 120 will be below the human
hearing range (or speaker reproduction range), and you'll just hear clicks.
Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@...