I am wondering if anyone can show me an example of using MOTM rack rails
to mount modules in a rack that can be ported around. I have looked at
typical 19-inch road cabinets and found that most of them are either too
deep or too short to be well suited. A 12-inch depth should be adequate
for any module, even with Stooge long brackets. Ideally I would like to
have three 10U wide rows of 5U height modules. That would be a tall
case, about 30 inches. I am thinking of using a second road case for my
Mackie 802-VLZ3 mixer and three 1U height pieces of equipment (MPX-1,
flash recorder, and power conditioner). I would consider going with two
two-tier cabinets of 10U width. My studio has 130U of modules, and I'd
like to be able to take at 30 to 40U with me. 20U would be a bit austere.
Any suggestions appreciated.
TIA,
Richard Brewster
http://www.pugix.com