Archive of the former Yahoo!Groups mailing list: MOTM

a) Things were a bit sluggish the past week as I wrapped up (literally) the sale
of my Moog 55. It took a friend and I about 4 1/2 hours to pack it all up. In
it's place is an empty Stooge Larry cabinet. Maybe one day it will have MOTM
modules in it (ha!). I also have the top 2-row cabinet, but that won't fit
unless I remove an wall existing shelf. It's always something......

b) As previously stated, the focus this week is on assembled backlog. I will
ship between 15 and 20 MOTM 2.0 orders, though later in the week (Friday/Sat).
The weekend is reserved for a few repairs I have to ship out. The week of the
14th will be a very minimal MOTM week as I have a new local sales rep that I
have to "babysit" and take him to all the local Dallas accounts. But the week of
the 21st I will be back to my 'regular' schedule (whatever that means).

c) There are a few older power supply/rails types of orders that will ship this
week. I ran out of MOTM-900 kits, I will make more up.

d) I am shipping 20 Frac modules to AH tomorrow, if you want one now is a good
time to get them. I will have prototypes of the Frac VCO in late June.

e) I just spent $480 on a set of new development tools/eval boards for a future
project that may be a 'dead end' but hopefully not (hardware is a bit
'oblique'). The eval board was a total P.O.S. (I have designed eval boards for
TI, Maxim and Cirrus Logic so I'm pretty sure I can recognize a P.O.S. eval
board). In fact I have to hack it just to make it useable but it does look
promising. More details to follow. This is just to show that I am ∗always∗ on
the look-out for new ICs/etc that can be used in MOTM. This particular IC is not
just for MOTM, I hope to make something any modular family can use (it's not a
module per se).

Paul S.