At 7:47 PM -0600 2007/01/25, John Loffink wrote:
>Has anyone successfully mounted the PRD Products Lens/Bezel from Digi-Key
>(#PRD360B-ND) in the TL-904 Stooge panel with the pre-cut square hole?
>Pressing the rear locking snaps into the bezel ends up bending the bezel as
>the snaps, in combination with the bezel, exceed the width of the cutout.
Mine were quite tight too. I used a flat file along the inside edges
of the bezel cutout to give it more room. About a millimeter on each
edge was enough, IIRC. Wrap your panel up in a towel and be careful
with the file so that it doesn't slip and scrap the panel. File from
the backside to be extra safe.