Nice overall explanation, Mark.
Regarding the snippet below, I wanted to point out that although MOTM
output level are typically 10Vpp, MOTM modules can put out up to 28Vpp
or so (limited by the power supply rails). The 510 Wave Warper is one.
Some of the filters can put out high levels too, and the 190 VCA's will
pass large signals through.
Richard Brewster
http://www.pugix.comMark wrote:
> Pretty much everything, with the exception of tube gear, that runs
> off of AC uses -15/+15 volt rails internally. MOTM is no exception.
> As long as the input voltage does not exceed the rails, damage should
> not occur. So you should be extra cautious when going from "+4dB"
> (which is typically around 20Vpp, but can be as high as 28Vpp) to
> effect pedals that run off of lower voltages such as 9V batteries.
> The outputs of MOTM modules are much lower -- 10Vpp is somewhere
> between "+4dB" and "-10db". I have connected MOTM to pedals from
> Boss, DOD, Electro-Harmonix, Ibanez, Morley, Mutron, Pearl, Sovtek,
> etc. without any problems.
>
>
>