I would say that's a good guess! (needing more coffee now...)
----- Original Message -----
From: "Richard Brewster" <pugix@...>
To: "groovyshaman" <groovyshaman@...>
Cc: "Paul Schreiber" <synth1@...>; "MOTM litserv"
<motm@yahoogroups.com>
Sent: Saturday, May 27, 2006 10:22 AM
Subject: Re: [motm] Kester solder part numbers
> I hazard a guess. If you have different diameters for the two different
> type of solder lying around, it is easy to tell which type you have.
> Important, because you don't want to confuse these.
>
> Richard Brewster
> http://www.pugix.com
>
> groovyshaman wrote:
> > Paul, just curious why you choose 0.031 diameter solder for 245 instead
of
> > 0.020? Is there some advantage or other reason...
> >
> > -George
> >
> > ----- Original Message -----
> > From: "Paul Schreiber" <synth1@...>
> > To: "MOTM litserv" <motm@yahoogroups.com>
> > Sent: Saturday, May 27, 2006 9:29 AM
> > Subject: [motm] Kester solder part numbers
> >
> >
> >
> >> For 331:
> >>
> >> 24-6337-6401
> >>
> >> For 245:
> >>
> >> 24-6337-8800
> >>
> >> Electronic suppliers will go by these numbers. Check Allied, Newark,
> >>
> > Mouser,
> >
> >> etc.
> >>
> >> Paul S.
> >>
> >
> >
> >
> >
> >
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
>
>
>