The problem with any plastic part is that, unless you can find exactly what
you want already made by somebody, the plastic parts would require the
making of a plastic injection mold. The cost to have even the simplest mold
made is up around $20,000. Minimum parts quantity would probably be in the
neighborhood of 20,000 pieces. There are methods of doing very small runs
of plastic parts (<10) but those methods have a high per part cost.
My company buys some plastic parts which are injection molded. The cost is
reasonable, but we buy 1.5 million identical parts every year.
Paul H.
----- Original Message -----
From: "Geoff" <overand@...>
To: "MOTM List" <motm@yahoogroups.com>
Sent: Saturday, December 03, 2005 7:15 PM
Subject: Re: [motm] Re: My initial take on the panel discussion
>I still think that the solution is clear plastic strips, I shaped, with
> the top and bottom
> section of the 'I' being secured underneath the panel's screw mounts,
> and with a
> white/whatever line silkscreened on the narrow part. This sort of thing
> ∗seems∗
> easy enough to do, assuming you could find the right company (companies?)
> to cut the plastic and do the silkscreening. I'm imagining plastic
> strips no thicker
> than 35mm film is, and about 2 or 3 mm wide in the long section.
>
> -Geoff
>
> Robert van der Kamp wrote:
>
>>On Saturday 03 December 2005 22:07, Paul Haneberg wrote:
>>
>>
>>>Actually, if things work out we may be able to remedy
>>>this.
>>>
>>>We may be able to offer a service where you could send us
>>>any existing panel and we could use the laser etcher to
>>>burn the paint off the edges, either all four or just the
>>>sides. It really depends on just how fine an edge we
>>>could get with the etcher burning through the Polan
>>>finish.
>>>
>>>
>>
>>I see! That could do the trick alright. Too bad though I
>>have the 'damage' the panels. No way back then. But I'd
>>seriously consider it yes.
>>
>>- Robert
>>
>>
>>
>>
>>Yahoo! Groups Links
>>
>>
>>
>>
>>
>>
>>
>>
>>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>