Actually, if things work out we may be able to remedy this.
We may be able to offer a service where you could send us any existing panel
and we could use the laser etcher to burn the paint off the edges, either
all four or just the sides. It really depends on just how fine an edge we
could get with the etcher burning through the Polan finish.
Paul H.
----- Original Message -----
From: "Robert van der Kamp" <robnet@...>
To: "MOTM List" <motm@yahoogroups.com>
Sent: Saturday, December 03, 2005 4:08 PM
Subject: Re: [motm] Re: My initial take on the panel discussion
> On Saturday 03 December 2005 21:34, mate_stubb wrote:
>> Nope, never found it either. You can buy brass U channel
>> at hobby shops that will slip right on, but it's too
>> thick, and pushes the modules out of their mounting.
>>
>> I always thought that the thing to find would be a thin
>> foil, sticky on one side. Then the problem becomes
>> building a jig to install it exactly aligned every time.
>
> Yes, I though of that too, and came with the same
> conclusions. Bleh.
>
> Could be a nice Stooge Inc. product if you actually can
> think of a solution (apart from new panels that is).
>
> - Robert
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>