Depending on your cabinet, you may be able to mount the larger supply
near to the MOTM-900 panel. You may be able to reuse the original AC
wiring from the panel to the new supply. And you can move the
12-connector distribution board from the MOTM0-900 panel and locate it
in a more convenient spot. I use dot com cabinets and mount the MOTM
power supply panels on the back with the supply chassis fastened down to
the wood just in front of the panel. I mount it length-wise to make
more clearance for modules in front of it.
-Richard Brewster
Greg Amann wrote:
> The 800 mA Power One supply that comes in the MOTM-900 is a different
> size (namely, smaller) than the HBB15-1.5A. Check oot either the
> Power One site or DigiKey: both list the dimensions of the supplies.
> The larger supplies will not be "screw compatible" with the 3U '900
> mounting panel.
>
> PLL, BFG
>
>
> synth1@... wrote:
>
>> > I am thinking big and would like to order a 1.5 amp power one linear
>> > supply HBB15-1.5-A or a 3 amp HCC15-3-A (i know this one is a bit
>> > bigger)...
>> >
>> > Can I just take out the supply from the MOTM-900 and replace it
>> with one
>> > of the above, will that work??? Does the fuse need to be changed in the
>> > plug????
>> >
>>
>> Just the fuse. The fuse rating you need is printed on the side of the
>> power supply. I use standard 5mm X 20mm fuses, "Slo-Blo" type from
>> Bussman
>> or Littelfuse.
>>
>> Paul S.
>>
>>