I'm definitely interested! My idea is to have two of these, one below each
row of MOTM in my SKB mixer case. The jacks in the upper multiplier panel
would be wired/normalled to the corresponding jacks in the lower multiplier
panel so I can patch between rows without having lots of cords over the
faces of the lower row of MOTM (or was that already Larry's Magic Bus idea
that I just didn't understand properly ... ?).
-Doug
ceres@...At 10:31 PM 11/13/99 -0600, you wrote:
>From: "Paul Schreiber" <synth1@...>
>
>I've found a 1U tall, 19" wide panel design from 0.090 thick aluminum that
>will be rigid enough for mults. I don't think the 0.035 difference will
>matter all
>that much, being in-between MOTM rows. My sheet metal supplier makes 500
>a month of these as patch panels for a telcom company.
>
>I would sell this as a "semi-kit": just the panel and jacks. You would
>decide yourself how to wire it up.
>(Wire not provided). I may make a small number of units up for fully
>assembled systems.
>
>Any interest? If nothing else, makes connectiong to my Pro 2000 easier! (as
>opposed to
>Larry's Magic Kenton Ears)
>
>Paul S.