Hi Gert/list,
I'm about to do this right now.
I found the VW1 and VW2 pairs of stubs.
I can just re-connect each one with jumper wire, correct?
I don't need a resistor or anything?
Thanks.
---Ben
--- In motm@yahoogroups.com, "Gert Jalass" <synth@g...> wrote:
> Hi Ben,
>
> this can be done pretty straightforward - on the PCB (of the Power One) you can spot
(the remains of) two jumpers (VW1 and VW2). "Re-install" them and the supply will provide
+- 12V. You may need to adjust the two trimmers (labelled "-V ADJ" and "+V ADJ") to trim
to the expected output voltage.
>
> Gert
> ----- Original Message -----
> From: ben vehorn
> To: Sent: Sunday, May 15, 2005 4:17 PM
> Subject: [motm] While we're talking about power supplies...
>
>
> How difficult is it to switch an MOTM 900 over for 12v use?